Steel handled tool used to punch round holes for studs. Sized 5/16" to allow for 3/8" tap. Learn More

Cody’s Drift has a slender design because to many drifts have a bulky striking surface. This makes it harder to see tool placement and alignment. Cody’s drift has a proportional size for the striking surface, not too big or too small. The handle is a welded mild steel handle with a rubber grip, eliminating the need to replace and maintain handles. Each handle has a hand forged heel check. All drifts are made from high quality H13 tool steel. Learn More

Cody’s Forepunch has a slender design because to many drifts have a bulky striking surface. This makes it harder to see tool placement and alignment. Cody’s forepunch has a proportional size for the striking surface, not too big or too small. The handle is a welded mild steel handle with a rubber grip, eliminating the need to replace and maintain handles. Each handle has a hand forged heel check. All forepunches are made from high quality H13 tool steel. Learn More

Center punch with hardened point. Enkay Products has been an importer and distributor of hand tools, drill accessories, hobby tools and polishing accessories since 1952. Enkay's mission is to provide customers with a less expensive alternative to the larger more expensive tool distributors without compromising quality. Learn More

The Flatland Forge 3/8" Stud Punch with Counter Sink built in to prepare the hole for tapping. Steel handle with plastic grip. Learn More

The Jim Blurton clipping punch with welded handle is designed to set clips. The head of the tool is positioned under the center to maximize the power of the hammer blow and the height of the clipping punch is designed to give good visibility to the blade during use. The clipping punch is made from S1 tool steel, and incorporates a welded on steel handle which is ergonomically designed with a non-slip grip on the handle. Learn More

The Jim Blurton draft stamp is a larger bodied stamp designed for working on larger shoes, allowing better dissipation of heat. It has a large head ideal for using with a striker and is designed to fit E Head Nails size 10, 12 and 14. The draft stamp is made from hardened and tempered H13 tool steel. The handle is 16” long to keep the users hand away from the hot steel and is made from high-quality hickory. Maintenance: The Jim Blurton draft stamp offers the best performance when it is maintained well. To sharpen the draft stamp it is recommended that this is done at normal forging temperatures and allowed to air cool. The draft stamp should ideally be placed on the side of the forge whilst cooling. It is not recommended that the draft stamp is placed on a cold surface as sudden cooling may cause stress fractures. Any burrs that may occur on the head should be regularly ground back. Learn More

The Jim Blurton 3/8th stud punch is made from S1 tool steel, which is an air hardened tool steel that can be easily maintained. This hand held tool has been designed to punch a hole in the shoe to allow the use of a stud. Learn More

The Jim Blurton 5/16th stud punch is made from S1 tool steel, which is an air hardened tool steel that can be easily maintained. This hand held tool has been designed to punch a hole in the shoe to allow the use of a stud. Learn More

Learn More